Step 1. Insert the key into the ignition and turn it to the “On” position. Be sure not to start the engine. Step 2. Locate the maintenance light on the dashboard. Press and hold the button until the maintenance light begins to flash. Step 3. Release the button, then press and hold it again for a few seconds. How to reset oil and scheduled Maintenance light on combination meter and navigation they are both done at the same time. The New 2022 NX and 2023 Lexus RX. 1) Turn key to position 2. 2) Press/release the R button to show the next service due light. Release button. 3) Turn key to Off. 4) Press and HOLD the same R button to view the service light, THEN, within 2 seconds, turn key to position 2. 5) Wait up to 10 second and the light will reset to show new service . C. The following are the steps to follow to reset the maintenance light on a Honda CR-V: Insert the key into the ignition and turn the accessories (ACC) ON without starting the engine. You will find the Select /Reset button on the steering wheel or a knob on the dash of your car (Depending on the model year). That it is the full procedure how to reset service light indicator Nissan Frontier. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd, for Nissan cars. Or any warning light for service reminder which appears on the display. Do you have a 2004-2006 Lexus RX-330 with a Maintenance required light illuminated on the dash? Watch this short video for more information. Press and hold the trip reset button near the odometer until “Trip A” appears on the central screen. Turn the key back to “Off.”. While pressing the button to reset the trip, turn the key back to the “On” position. Keep holding the trip reset button until the miles section of the odometer flashes zero. At this point, the maintenance Start the engine and press the odometer button to bring up the trip meter A reading. Make sure odometer (ODO) is displaying total mileage (usually the ‘A’ display). Turn off vehicle, if on. While vehicle is off, press and hold ODO reset / readout button. Continuing to hold down ODO button, turn the key in ignition. until dash lights come on. Using the Trip Meter Method for Resetting the Light. Using the trip meter method is a simple and effective way to turn off the maintenance light on your car. First, make sure your car is turned off and the key is out of the ignition. Then, locate your trip meter button and hold it down while turning on the car. Press and hold the ODO reset / readout button while the engine is off. Turn the key in the ignition while maintaining pressure on the ODO button. till the dash lights turn on. Avoid starting the car. Release the ODO button once it starts to show zeros, then flip the key back to the “off” position. hs0t.